---------------------------------------------------------- RV10-List Digest Archive --- Total Messages Posted Fri 11/08/13: 9 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 06:01 AM - Re: Tires and tubes (Bill Watson) 2. 12:50 PM - Re: Cabin Cover Headliner (bob88) 3. 01:20 PM - Re: Cabin Cover Headliner (johngoodman) 4. 02:08 PM - Re: Cabin Cover Headliner (bob88) 5. 02:27 PM - Re: Cabin Cover Headliner (johngoodman) 6. 03:07 PM - Re: Cabin Cover Headliner (bob88) 7. 03:25 PM - Re: Re: Cabin Cover Headliner (Bill Watson) 8. 06:23 PM - Re: Coming Soon - The List of Contributors - Please Make A Contrib... (MB86967@aol.com) 9. 07:05 PM - Re: Coming Soon - The List of Contributors - Please Make A Contrib... (Pascal) ________________________________ Message 1 _____________________________________ Time: 06:01:31 AM PST US From: Bill Watson Subject: Re: RV10-List: Tires and tubes Not in my kit. I just replaced all my tubes with the Leakguards. The ones I took off were not Leakguards. My experience has been the same with the non-leakguards. I will know in a few months whether the Leakguards are better. Why did I replace them all? Because 1) I swapped tires for even wear and one is supposed to replace the tubes at that point as I understand it, and 2) I had a badly cracked front Matco wheel which I replaced. Just FYI, I did replace the kit supplied wheel with the Matco WHLNW511.25 which as others have explained, is a better spec for this application. http://www.mykitlog.com/users/display_log.php?user=MauleDriver&project=224&category=7984&log=180210&row=1 Bill "trying to conjure up a heat duct scheme for the rear heat vents so my copilot doesn't have to pack a blanket" Watson On 11/7/2013 3:54 PM, Rob Kochman wrote: > Isn't "leakguard" the stock tubes Van's sells? I'm still finding they > lose about 10 psi over 2-3 months, so would rather go with something > less leaky. > > > On Fri, Nov 1, 2013 at 1:54 PM, Kelly McMullen > wrote: > > This is what I have my -10 sitting on: > 15/600-6 "Leakguard" Butyl Tube with the "New Easy Valve" for the > mains, and 500-5 "Leakguard" Butyl Tube with the TR-67 Valve for the > nose. > The tube for the mains was designed for Cirri, that have similar > wheel pants access issues. > Leakguard is Desser's in-house branding of what is supposed to be > same as Air Stop at lower cost. I think I put air in them once > over past year to make moving fuselage easier. > > > On Fri, Nov 1, 2013 at 1:03 PM, Rob Kochman > wrote: > > Based on feedback here, I think I'm going to stick with the > Aero Classics tires, but switch to Michelan Airstop tubes. > Anyone have an issue with this combination? Are there > different valve stem angle options with these tubes? Thanks > much... > > -Rob > > -- > Rob Kochman > RV-10 Flying since March 2011 > Woodinville, WA > http://kochman.net/N819K > > * > > _blank">www.aeroelectric.com > .com" target="_blank">www.buildersbooks.com > ="_blank">www.homebuilthelp.com > ="_blank">www.mypilotstore.com > ank">www.mrrace.com > _blank">http://www.matronics.com/contribution > get="_blank">http://www.matronics.com/Navigator?RV10-List > tp://forums.matronics.com > * > > > -- > > - sent from the microchip implanted in my forearm > > * > > _blank">www.aeroelectric.com > .com" target="_blank">www.buildersbooks.com > ="_blank">www.homebuilthelp.com > ="_blank">www.mypilotstore.com > ank">www.mrrace.com > _blank">http://www.matronics.com/contribution > get="_blank">http://www.matronics.com/Navigator?RV10-List > tp://forums.matronics.com > * > > > -- > Rob Kochman > RV-10 Flying since March 2011 > Woodinville, WA > http://kochman.net/N819K > * > > * ________________________________ Message 2 _____________________________________ Time: 12:50:07 PM PST US Subject: RV10-List: Re: Cabin Cover Headliner From: "bob88" John: How did you finish the depressions around the hinge bolts? Read this topic online here: http://forums.matronics.com/viewtopic.php?p=412466#412466 ________________________________ Message 3 _____________________________________ Time: 01:20:19 PM PST US Subject: RV10-List: Re: Cabin Cover Headliner From: "johngoodman" I just covered it with the fabric as if the depression wasn't there. It stays in place with a touch of rubber cement and the McMaster Carr edging. No air leaks because of the edging. John -------- #40572 Phase One complete and flying. Read this topic online here: http://forums.matronics.com/viewtopic.php?p=412467#412467 ________________________________ Message 4 _____________________________________ Time: 02:08:49 PM PST US Subject: RV10-List: Re: Cabin Cover Headliner From: "bob88" Thanks for the prompt reply. Do you mind telling me which edging you used? Thanks, Bob Read this topic online here: http://forums.matronics.com/viewtopic.php?p=412470#412470 ________________________________ Message 5 _____________________________________ Time: 02:27:30 PM PST US Subject: RV10-List: Re: Cabin Cover Headliner From: "johngoodman" I can't find the exact part number, but it's the same stuff everyone else is using from McMaster Carr. John -------- #40572 Phase One complete and flying. Read this topic online here: http://forums.matronics.com/viewtopic.php?p=412473#412473 ________________________________ Message 6 _____________________________________ Time: 03:07:20 PM PST US Subject: RV10-List: Re: Cabin Cover Headliner From: "bob88" Are you rerferring to the weather stripping around the door? Read this topic online here: http://forums.matronics.com/viewtopic.php?p=412475#412475 ________________________________ Message 7 _____________________________________ Time: 03:25:24 PM PST US From: Bill Watson Subject: Re: RV10-List: Re: Cabin Cover Headliner It is the 'weatherstripping' but do take some care with the ordering. The McMaster Carr part I used was 1120A411 - bulb opposite grabber (very important, especially if using a headliner), 1/4" edge. I also played around with the 3/8" edge. If you go this route, decide what edge width you want, make it that width, and order the weatherstripping size you want. There's plenty of info in the archives. On 11/8/2013 5:27 PM, johngoodman wrote: > > I can't find the exact part number, but it's the same stuff everyone else is using from McMaster Carr. > John > > -------- > #40572 Phase One complete and flying. > > > Read this topic online here: > > http://forums.matronics.com/viewtopic.php?p=412473#412473 > > ________________________________ Message 8 _____________________________________ Time: 06:23:28 PM PST US From: MB86967@aol.com Subject: Re: RV10-List: Coming Soon - The List of Contributors - Please Make A Contrib... hello Please take me off the rv10 list Thanks In a message dated 11/7/2013 3:58:35 A.M. Eastern Standard Time, dralle@matronics.com writes: --> RV10-List message posted by: Matt Dralle Each year at the end of the List Fund Raiser, I post a message acknowledging everyone that so generously made a Contribution to support the Lists. Its my way of publicly thanking everyone that took a minute to show their appreciation for the Lists. Please take a moment and assure that your name is on that List of Contributors (LOC)! As a number of members have pointed out over the years, the List seems at least as valuable a building / entertainment tool as your typical magazine subscription! Assure that your name is on this year's LOC! Show others that you appreciate the Lists. Making a Contribution to support the Lists is fast and easy using your Credit card or Paypal on the Secure Web Site: http://www.matronics.com/contribution or by dropping a personal check in the mail to: Matt Dralle / Matronics 581 Jeannie Way Livermore CA 94550 I would like to thank everyone that has so generously made a Contribution thus far in this year's List Fund Raiser! Remember that its YOUR support that keeps these Lists going and improving! Don't forget to include a little comment about how the Lists have helped you! Best regards, Matt Dralle Matronics Email List Administrator ________________________________ Message 9 _____________________________________ Time: 07:05:32 PM PST US From: "Pascal" Subject: Re: RV10-List: Coming Soon - The List of Contributors - Please Make A Contrib... Use the Matronics List Features Navigator to browse_http://www.matronics.com/Navigator?RV10-List =93= for UnSubscription From: MB86967@aol.com Sent: Friday, November 08, 2013 6:22 PM Subject: Re: RV10-List: Coming Soon - The List of Contributors - Please Make A Contrib... hello Please take me off the rv10 list Thanks In a message dated 11/7/2013 3:58:35 A.M. Eastern Standard Time, dralle@matronics.com writes: Each year at the end of the List Fund Raiser, I post a message acknowledging everyone that so generously made a Contribution to support the Lists. Its my way of publicly thanking everyone that took a minute to show their appreciation for the Lists. Please take a moment and assure that your name is on that List of Contributors (LOC)! As a number of members have pointed out over the years, the List seems at least as valuable a building / entertainment tool as your typical magazine subscription! Assure that your name is on this year's LOC! Show others that you appreciate the Lists. Making a Contribution to support the Lists is fast and easy using your Credit card or Paypal on the Secure Web Site: http://www.matronics.com/contribution or by dropping a personal check in the mail to: Matt Dralle / Matronics 581 Jeannie Way Livermore CA 94550 I would like to thank everyone that has so generously made a Contribution thus far in this year's List Fund Raiser! Remember that its YOUR support that keeps these Lists going and improving! Don't forget to include a little comment about how the Lists have helped you! Best regards, Matt Dralle Matronics Email List ======================= ------------------------------------------------------------------------------------- Other Matronics Email List Services ------------------------------------------------------------------------------------- Post A New Message rv10-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/RV10-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com Full Archive Search Engine http://www.matronics.com/search 7-Day List Browse http://www.matronics.com/browse/rv10-list Browse Digests http://www.matronics.com/digest/rv10-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution ------------------------------------------------------------------------------------- These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.