Today's Message Index:
----------------------
1. 08:10 AM - WTB: RV-10 Throttle Quadrant (Tim Olson)
2. 11:09 AM - Re: RV-10 Quadrant Mounting Hole Dimensions (Tim Olson)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | WTB: RV-10 Throttle Quadrant |
Does anyone have a new Van's RV-10 throttle
quadrant that they'd want to sell *without* the
cables?
Tim
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: RV-10 Quadrant Mounting Hole Dimensions |
Just circling back. I did get the info I needed.
Tim
On 2/16/2015 2:49 PM, Tim Olson wrote:
>
> Hey all,
> If there's anyone who has their RV-10 throttle quadrant
> not installed who could measure the spacing
> in both directions for the mounting holes on the top,
> I'm in need of the measurements.
>
> I'm going to have to modify the RV-14 a bit probably,
> as they haven't planned for a quadrant at this time,
> and I'm thinking I'll just use the RV-10 quadrant.
> I just need to see how much I'll have to shuffle things
> around to make it fit.
>
> Also, if you have the distance from the forward
> most (skinny end, not lever end) holes, to the
> furthest forward part of the quadrant, that would
> be good too, so I know how far it sticks up into
> the forward fuselage forward of the panel.
> The RV-14 has a goofy fuse box pillar (that I
> will also have to modify) in that area so I need
> to modify that as well. So I'm verifying fit.
>
> Thanks!
> Tim
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|