---------------------------------------------------------- RV10-List Digest Archive --- Total Messages Posted Sun 02/21/16: 5 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 03:08 AM - Bonaco Brake Lines Too Short! (Patrick Pulis) 2. 07:47 AM - Re: Bonaco Brake Lines Too Short! (Phillip Perry) 3. 11:17 AM - Re: Bonaco Brake Lines Too Short! (Patrick Pulis) 4. 12:22 PM - Re: Bonaco Brake Lines Too Short! (Rick & Sandra Lark) 5. 08:14 PM - Re: Bonaco Brake Lines Too Short! (Patrick Pulis) ________________________________ Message 1 _____________________________________ Time: 03:08:01 AM PST US Subject: RV10-List: Bonaco Brake Lines Too Short! From: Patrick Pulis Hi team I purchased to pre-fabricated Bonaco brake lines some time ago and went to fit them today, however the two lines that interconnect the pilot and co-pilot brake master cylinders are only 31.5" long, as opposed to the 43" called for in the plans. Has anyone else encountered this problem with the Bonaco brake line kit? Warm regards Patrick ________________________________ Message 2 _____________________________________ Time: 07:47:28 AM PST US From: Phillip Perry Subject: Re: RV10-List: Bonaco Brake Lines Too Short! I believe they modeled them after my setup a number of years ago. Here's a t our. https://youtu.be/gemgQmVsOYI Also, you'll want to make sure you adel clamp the tunnel lines frequently. They're long so they don't sag down and rub on rivet heads. I used the fac tory clamp locations and then added a 2nd pair between those higher on the t unnel walls. So it kinda makes some S-Turns down the sides of the tunnel. Phil Sent from my iPhone > On Feb 21, 2016, at 5:01 AM, Patrick Pulis wro te: > > > Hi team > > I purchased to pre-fabricated Bonaco brake lines some time ago and went to fit them today, however the two lines that interconnect the pilot and co-pi lot brake master cylinders are only 31.5" long, as opposed to the 43" called for in the plans. > > Has anyone else encountered this problem with the Bonaco brake line kit? > > Warm regards > > Patrick > ========================== ========= ========================== ========= ========================== ========= ========================== ========= ========================== ========= > > > ________________________________ Message 3 _____________________________________ Time: 11:17:25 AM PST US Subject: Re: RV10-List: Bonaco Brake Lines Too Short! From: Patrick Pulis Thanks Phil I'm only replacing the lines under the panel. They two in question are way t oo short. Warm regards Patrick > On 22 Feb 2016, at 02:13, Phillip Perry wrote: > > I believe they modeled them after my setup a number of years ago. Here's a tour. > > https://youtu.be/gemgQmVsOYI > > Also, you'll want to make sure you adel clamp the tunnel lines frequently. They're long so they don't sag down and rub on rivet heads. I used the f actory clamp locations and then added a 2nd pair between those higher on the tunnel walls. So it kinda makes some S-Turns down the sides of the tunnel . > > Phil > > > > > > Sent from my iPhone > >> On Feb 21, 2016, at 5:01 AM, Patrick Pulis wr ote: >> > >> >> Hi team >> >> I purchased to pre-fabricated Bonaco brake lines some time ago and went t o fit them today, however the two lines that interconnect the pilot and co-p ilot brake master cylinders are only 31.5" long, as opposed to the 43" calle d for in the plans. >> >> Has anyone else encountered this problem with the Bonaco brake line kit? >> >> Warm regards >> >> Patri======================= ======================= >> http://www.matronics.com/Naviga============== ========================== ============; - MATRONICS WEB FORUMS - >> >> <======================== ========================== ===== ========================== ========================== -========================= ========================== ========================== -========================= ========================== ======== ________________________________ Message 4 _____________________________________ Time: 12:22:07 PM PST US From: "Rick & Sandra Lark" Subject: RE: RV10-List: Bonaco Brake Lines Too Short! Patrick, I=99m away from my -10 until April 3rd, but I=99m wondering if you had the wrong lines sent to you. I recall the 31=9D lines where for down the gear legs. Rick #40956 Southampton, Ont From: owner-rv10-list-server@matronics.com [mailto:owner-rv10-list-server@matronics.com] On Behalf Of Patrick Pulis Sent: Sunday, 21 February, 2016 2:11 PM Subject: Re: RV10-List: Bonaco Brake Lines Too Short! Thanks Phil I'm only replacing the lines under the panel. They two in question are way too short. Warm regards Patrick On 22 Feb 2016, at 02:13, Phillip Perry wrote: I believe they modeled them after my setup a number of years ago. Here's a tour. https://youtu.be/gemgQmVsOYI Also, you'll want to make sure you adel clamp the tunnel lines frequently. They're long so they don't sag down and rub on rivet heads. I used the factory clamp locations and then added a 2nd pair between those higher on the tunnel walls. So it kinda makes some S-Turns down the sides of the tunnel. Phil Sent from my iPhone On Feb 21, 2016, at 5:01 AM, Patrick Pulis wrote: Hi team I purchased to pre-fabricated Bonaco brake lines some time ago and went to fit them today, however the two lines that interconnect the pilot and co-pilot brake master cylinders are only 31.5" long, as opposed to the 43" called for in the plans. Has anyone else encountered this problem with the Bonaco brake line kit? Warm regards Patri======================= ======================= <======================== ====== ========== >www.buildersbooks.com matronics.com/contribution ========== ://www.matronics.com/Navigator?RV10-List ========== cs.com ========== matronics.com/contribution ========== _____ No virus found in this message. Checked by AVG - www.avg.com 02/21/16 ________________________________ Message 5 _____________________________________ Time: 08:14:32 PM PST US Subject: Re: RV10-List: Bonaco Brake Lines Too Short! From: Patrick Pulis Yep, I've used the longer lines down the gear legs, thanks for the heads up R ick. Warm regards Patrick > On 22 Feb 2016, at 06:48, Rick & Sandra Lark wrote: > > Patrick, I=99m away from my -10 until April 3rd, but I=99m won dering if you had the wrong lines sent to you. I recall the 31=9D lin es where for down the gear legs. > Rick > #40956 > Southampton, Ont > > From: owner-rv10-list-server@matronics.com [mailto:owner-rv10-list-server@ matronics.com] On Behalf Of Patrick Pulis > Sent: Sunday, 21 February, 2016 2:11 PM > To: rv10-list@matronics.com > Subject: Re: RV10-List: Bonaco Brake Lines Too Short! > > Thanks Phil > > I'm only replacing the lines under the panel. They two in question are way too short. > > Warm regards > > Patrick > > On 22 Feb 2016, at 02:13, Phillip Perry wrote: > > I believe they modeled them after my setup a number of years ago. Here's a tour. > > https://youtu.be/gemgQmVsOYI > > Also, you'll want to make sure you adel clamp the tunnel lines frequently. They're long so they don't sag down and rub on rivet heads. I used the f actory clamp locations and then added a 2nd pair between those higher on the tunnel walls. So it kinda makes some S-Turns down the sides of the tunnel . > > Phil > > > > > > Sent from my iPhone > > On Feb 21, 2016, at 5:01 AM, Patrick Pulis wro te: > > > Hi team > > I purchased to pre-fabricated Bonaco brake lines some time ago and went to fit them today, however the two lines that interconnect the pilot and co-pi lot brake master cylinders are only 31.5" long, as opposed to the 43" called for in the plans. > > Has anyone else encountered this problem with the Bonaco brake line kit? > > Warm regards > > Patri===================== > <="" span=""> > <========================= ===== > > > > > ========================= ========== >www.buildersbooks.com matronics.com/contribu tion ========== ://www.matronics.com/Navigator?RV10-List ========== cs.com ========== matron ics.com/contribution ========= > No virus found in this message. > Checked by AVG - www.avg.com > Version: 2016.0.7442 / 02/21/16 ------------------------------------------------------------------------------------- Other Matronics Email List Services ------------------------------------------------------------------------------------- Post A New Message rv10-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/RV10-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com Full Archive Search Engine http://www.matronics.com/search 7-Day List Browse http://www.matronics.com/browse/rv10-list Browse Digests http://www.matronics.com/digest/rv10-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution ------------------------------------------------------------------------------------- These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.