Today's Message Index:
----------------------
1. 06:43 AM - Aerosport Side Vents - Rear Interior Panel (Phillip Perry)
2. 07:14 AM - Re: Aerosport Side Vents - Rear Interior Panel (John Trollinger)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Aerosport Side Vents - Rear Interior Panel |
I've spent the better part of 6 hours trying to fit one side vent on my
interior panels so I can complete my W&B.
In the process I've invented cuss words that even a sailor at sea would be
ashamed of saying if there were a shipmate standing near.
The problem is the duct that goes between the Vans inlet that ducts the air
to the interior panel vent cover. First, it doesn't sit flat against the
backside of the skin because of the rivets and doubler holding Vans vent.
So every attempt to seat it is different from the previous attempt. And
second, the duct repeatedly falls off the backside of the interior panel
every time I try to work it into position.
I have to be the problem because I haven't heard any complaints from other
folks getting these things to fit.
I've notched the duct as described in the installation documents, so I
don't believe that is the problem.
Has anyone found a technique, tip, or even modification to make this as
simple as it appears it should be?
Thanks,
Phil
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Aerosport Side Vents - Rear Interior Panel |
I had the same issues you did.. I had to cut down the duct to get it to fit
at all.. I do not remember if I just threw away the vents or finally got it
to work..
On Thu, Mar 23, 2017 at 9:40 AM, Phillip Perry <philperry9@gmail.com> wrote:
> I've spent the better part of 6 hours trying to fit one side vent on my
> interior panels so I can complete my W&B.
>
> In the process I've invented cuss words that even a sailor at sea would be
> ashamed of saying if there were a shipmate standing near.
>
> The problem is the duct that goes between the Vans inlet that ducts the
> air to the interior panel vent cover. First, it doesn't sit flat against
> the backside of the skin because of the rivets and doubler holding Vans
> vent. So every attempt to seat it is different from the previous
> attempt. And second, the duct repeatedly falls off the backside of the
> interior panel every time I try to work it into position.
>
> I have to be the problem because I haven't heard any complaints from other
> folks getting these things to fit.
>
> I've notched the duct as described in the installation documents, so I
> don't believe that is the problem.
>
> Has anyone found a technique, tip, or even modification to make this as
> simple as it appears it should be?
>
> Thanks,
> Phil
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|