Today's Message Index:
----------------------
1. 02:37 PM - RPM Sensor setting E-Mag Series 200-6XL with AFS 4500 EM (Mike Whisky)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | RPM Sensor setting E-Mag Series 200-6XL with AFS 4500 EM |
Hi,
installed my new E-MAG P200-6XL and had to rewire the AFS RPM sensor ( RPM signal
wired to the Mag) I also did change the pin from the 5V signal Pin 32 to the
12V signal pin 33. In the software setting the AFS 44500 EM asked for pulses
per 2 revolutions, E-MAg says it provides 3 pulses per revolution. I set it therefore
to 6.
Problem is now that I get 0 RPM reading and the familiar RPM circle gauge changed
in into a red multi-spike star see attached picture. Anyone has an idea what
gone wrong?
On the setting page I can see the pule count working.
Kind Regards
Michael
--------
RV-10 builder (flying)
#511
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=501652#501652
Attachments:
http://forums.matronics.com//files/img_7756_709.jpg
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|