RV12-List Digest Archive
Tue 08/24/10 |
Total Messages Posted: 1 |
Today's Message Index:
----------------------
1. 02:06 AM - Re: Day 21 (Daniel Schmid)
Message 1
INDEX Back to Main INDEX NEXT Skip to NEXT Message LIST Reply to LIST Regarding this Message SENDER Reply to SENDER Regarding this Message
Time: 02:06:28 AM PST US
From: Daniel Schmid <hufise@hotmail.com>
Subject: Day 21
Hi Albert
Gardner
i have an 6-32 NC Tap kit it contains an #36 Drill.
You can try to use the #40=2C do not use to mach force for the Tap after th
e
"knack" i think you have a big problem to remove the Tap.
Greetings
from Switzerland
with the lucky metric system.
Daniel
Schmid
RV-12 empennage Kit=2C wait for build advisor
From: ibspud@roadrunner.com
Subject: RV12-List: Day 21
Well we got the tail cone joined up today and are working on the rear windo
w. Plans say to drill the roll bar with #40 and then tap them 6-32. Tap d
rill for 6-32 is #37=2C does #40 work OK?Albert GardnerRV-10 N991RVYuma=2C
AZ
Other Matronics Email List Services
Post A New Message rv12-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/RV12-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com 7-Day List Browse http://www.matronics.com/browse/rv12-list Browse RV12-List Digests http://www.matronics.com/digest/rv12-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.