RV4-List Digest Archive
Sat 04/05/03 |
Total Messages Posted: 1 |
Today's Message Index:
----------------------
1. 07:49 PM - Re:Cowl inlet duct (Oldsfolks@aol.com)
Message 1
NEXT Skip to NEXT Message LIST Reply to LIST Regarding this Message SENDER Reply to SENDER Regarding this Message
Time: 07:49:57 PM PST US
From: Oldsfolks@aol.com
Subject: Re:Cowl inlet duct
--> RV4-List message posted by: Oldsfolks@aol.com
You should rough up the inside of the cowl where the inlet duct goes(With #40
grit sandpaper) and epoxy the duct in place. Use epoxy with cotton mill-ends
mixed in. I used a couple of pop rivets from the outside (CS 4-4 ) to be sure
they stay there.
This has worked well on both of my RV-4's.
Bob Olds A&P , EAA Tech. Counselor
RV-4 , N1191X , Flying Now
Charleston, Arkansas
"Real Aviators Fly Taildraggers"
Other Matronics Email List Services
Post A New Message rv4-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/RV4-List.htm Full Archive Search Engine http://www.matronics.com/search 7-Day List Browse http://www.matronics.com/browse/rv4-list Browse RV4-List Digests http://www.matronics.com/digest/rv4-list Browse Other Lists http://www.matronics.com/browse Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contributions
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.