----------------------------------------------------------
                           RV4-List Digest Archive
                                      ---
                     Total Messages Posted Sat 04/05/03: 1
           ----------------------------------------------------------
 
 
Today's Message Index:
----------------------
 
     1. 07:49 PM - Re:Cowl inlet duct  (Oldsfolks@aol.com)
 
 
 
________________________________  Message 1  _____________________________________


Time: 07:49:57 PM PST US
From: Oldsfolks@aol.com
Subject: RV4-List: Re:Cowl inlet duct

--> RV4-List message posted by: Oldsfolks@aol.com

You should rough up the inside of the cowl where the inlet duct goes(With #40 
grit sandpaper) and epoxy the duct in place. Use epoxy with cotton mill-ends 
mixed in. I used a couple of pop rivets from the outside (CS 4-4 ) to be sure 
they stay there.
This has worked well on both of my RV-4's.


Bob Olds   A&P , EAA Tech. Counselor
RV-4 , N1191X  ,  Flying Now
Charleston, Arkansas
"Real Aviators Fly Taildraggers"