Today's Message Index:
----------------------
1. 05:01 AM - Re: Ideas on how to attach hydraulic lines to gear legs... (rob ray)
2. 08:12 PM - 2005 List of Contributors (Update)... (Matt Dralle)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Ideas on how to attach hydraulic lines to gear legs... |
--> RV4-List message posted by: rob ray <smokyray@yahoo.com>
Hi Donna,
I have the exact same lines on my RV4 now. I used tie-wraps and electrical tape
for the first 10 years and recently replaced the lines. I attached them using
aluminum tape at the top, middle and bottom. Put some MHWH tape between the
line and the leg (prevents chafing) and tie-wrap them to hold while you wrap
the aluminum tape. The key is to put the line down the leading edge of the leg.
Now if you are installing wooden leg stiffeners (which I didn't like and removed)
you can drill a hole through them and they will "hold the line" for you.
Good Luck!
Rob Ray
Turrentine <dturren@sonic.net> wrote:
--> RV4-List message posted by: "Donna Turrentine"
Hello Everyone: I was wondering how everyone attached their hydraulic
lines to the gear legs. I bought the Teflon lines with stainless steel
braid and tried to install them to the gear legs with two clamps "tied"
together by a screw. I found the clamps interfered with my fiberglass
leg fairings. Any ideas on how to attach this line close to the gear
leg?
Thanks, Donna Turrentine
---------------------------------
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | 2005 List of Contributors (Update)... |
--> RV4-List message posted by: Matt Dralle <dralle@matronics.com>
Dear Listers,
There seemed to a number of members that were having a problem viewing the List
of Contributors this year, particularly for those using some versions of Outlook
and some web-based email clients. Just to make sure that everyone is properly
acknowledged for their generous support of the Lists this year, I have made
a simple web page with the current contributees as of 12/06/05. This can viewed
here:
http://www.matronics.com/ListOfContributors2005.html
Thank you to everyone that made a contribution this year. The Contribution web
site with all of this year's great gifts is still open for those of you that
would like to show your last minute support!
http://www.matronics.com/contribution
Thanks again to everyone that supported the Lists this year!
Matt Dralle
Matronics Email Lists Administrator
Matt G Dralle | Matronics | PO Box 347 | Livermore | CA | 94551
925-606-1001 V | 925-606-6281 F | dralle@matronics.com Email
http://www.matronics.com/ WWW | Featuring Products For Aircraft
do not archive
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|