----------------------------------------------------------
                           RV4-List Digest Archive
                                      ---
                     Total Messages Posted Tue 08/29/06: 1
           ----------------------------------------------------------
 
 
Today's Message Index:
----------------------
 
     1. 10:39 AM - Re: Front Spinner Bulkhead  (PGLong@aol.com)
 
 
 
________________________________  Message 1  _____________________________________


Time: 10:39:29 AM PST US
From: PGLong@aol.com
Subject: Re: RV4-List: Front Spinner Bulkhead

Ivan

I used a friend's Pin Mill, at least that's what I think is was. You could  
also use a vertical milling machine with a wood end router bit in it. This pin

mill was just a vertical hi speed spindle that had an end mill in it. I 
simply  set the gap to the table at 4-3/8" and moved the prop by hand under it
on a 
 smooth flat table. Guess you could even use a router if you come up with a  
way to maintain the proper gap. Anyway, that solved my problem.  

Pat  Long
PGLong@aol.com
N120PL
RV4
Bay City, Michigan
3CM

Do  Not Archive