Today's Message Index:
----------------------
1. 07:00 PM - Re: Front Spinner Bulkhead (H.Ivan Haecker)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Front Spinner Bulkhead |
Pat,
Thanks for the advice. I will find someone with a mill or, if not, then
try the router method. Either way, I feel this will be the best
solution. After all, I suppose someone designed the sizes of the spinner
and bulkheads based upon the prop being the correct thickness.
Ivan Haecker Do not archive
----- Original Message -----
From: PGLong@aol.com
To: rv4-list@matronics.com
Sent: Tuesday, August 29, 2006 12:38 PM
Subject: Re: RV4-List: Front Spinner Bulkhead
Ivan
I used a friend's Pin Mill, at least that's what I think is was. You
could also use a vertical milling machine with a wood end router bit in
it. This pin mill was just a vertical hi speed spindle that had an end
mill in it. I simply set the gap to the table at 4-3/8" and moved the
prop by hand under it on a smooth flat table. Guess you could even use a
router if you come up with a way to maintain the proper gap. Anyway,
that solved my problem.
Pat Long
PGLong@aol.com
N120PL
RV4
Bay City, Michigan
3CM
Do Not Archive
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|