---------------------------------------------------------- RV4-List Digest Archive --- Total Messages Posted Wed 08/30/06: 1 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 07:00 PM - Re: Front Spinner Bulkhead (H.Ivan Haecker) ________________________________ Message 1 _____________________________________ Time: 07:00:51 PM PST US From: "H.Ivan Haecker" Subject: Re: RV4-List: Front Spinner Bulkhead Pat, Thanks for the advice. I will find someone with a mill or, if not, then try the router method. Either way, I feel this will be the best solution. After all, I suppose someone designed the sizes of the spinner and bulkheads based upon the prop being the correct thickness. Ivan Haecker Do not archive ----- Original Message ----- From: PGLong@aol.com To: rv4-list@matronics.com Sent: Tuesday, August 29, 2006 12:38 PM Subject: Re: RV4-List: Front Spinner Bulkhead Ivan I used a friend's Pin Mill, at least that's what I think is was. You could also use a vertical milling machine with a wood end router bit in it. This pin mill was just a vertical hi speed spindle that had an end mill in it. I simply set the gap to the table at 4-3/8" and moved the prop by hand under it on a smooth flat table. Guess you could even use a router if you come up with a way to maintain the proper gap. Anyway, that solved my problem. Pat Long PGLong@aol.com N120PL RV4 Bay City, Michigan 3CM Do Not Archive