---------------------------------------------------------- RV6-List Digest Archive --- Total Messages Posted Mon 07/28/03: 3 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 09:04 AM - Re: canopy half (knepperh) 2. 09:26 PM - Fab Air Box (Mike Comeaux) 3. 10:25 PM - Re: Fab Air Box (Stein Bruch) ________________________________ Message 1 _____________________________________ Time: 09:04:27 AM PST US From: "knepperh" Subject: Re: RV6-List: canopy half --> RV6-List message posted by: "knepperh" HI BUD, JUST GOT BAACK FROM PACKWOOD, WHERE I WAS REBUILDING A DECK. THEY HAD A GREAT CAR SHOW THERE THIS WEEKEND. HOPE YOU ALL GOT HOME OK WITH THE CANOPY. HOW DID IT GO CUTTING THE FRONT HALF OFF? HAVE A GREAT DAY. HAROLD ----- Original Message ----- From: "Balone Marine" Subject: RV6-List: canopy half > --> RV6-List message posted by: Balone Marine > > looking for the aft or canopy half of the whole canopy > somebody out there cracked the windshield Excuse me > windscreen and had to buy a whole new canopy, I need > the slider part, Will pay shipping and? > Bud > > __________________________________ > > ________________________________ Message 2 _____________________________________ Time: 09:26:01 PM PST US From: "Mike Comeaux" Subject: RV6-List: Fab Air Box --> RV6-List message posted by: "Mike Comeaux" Any suggestions? After putting all components together the air box is barely touching the side of the air scoop. I already have the scoop glassed on & the air box all riveted togetther. How much does the engine move/vibrate? Any Recommendations? RV6A---0-360 Fixed Regards---Mike Comeaux mcomeaux@bendnet.net ________________________________ Message 3 _____________________________________ Time: 10:25:01 PM PST US From: "Stein Bruch" Subject: RE: RV6-List: Fab Air Box --> RV6-List message posted by: "Stein Bruch" The simple solution is simply to make a new plate for mounting the FAB to the Carb/Servo and make the center hole "off center"! I ended up making 3 of to get things perfect. Since Lycoming mounts the carbs/servos all over the place (Rarely in the center of the sump) this happens. My Fuel Injection Servo sits about 1.5" off of center, hence my requirement for a new plate that offsets the FAB to line up with the cowl inlet, Otherwise my FAB was hitting the side of the scoop also. Hope this helps! Cheers, Stein Bruch, RV6, AEIO-360/Fixed. -----Original Message----- From: owner-rv6-list-server@matronics.com [mailto:owner-rv6-list-server@matronics.com]On Behalf Of Mike Comeaux Subject: RV6-List: Fab Air Box --> RV6-List message posted by: "Mike Comeaux" Any suggestions? After putting all components together the air box is barely touching the side of the air scoop. I already have the scoop glassed on & the air box all riveted togetther. How much does the engine move/vibrate? Any Recommendations? RV6A---0-360 Fixed Regards---Mike Comeaux mcomeaux@bendnet.net