Today's Message Index:
----------------------
1. 09:54 AM - Re: Baffling (d.meloche@att.net)
2. 12:34 PM - Last "Official" Day To Make Your List Contribution!! (Matt Dralle)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
--> RV6-List message posted by: d.meloche@att.net
i found that measuring the distance between the baffles and the bottom of the
cowling was virtually impossible. after some thinking i came up with a method
that worked quite well. i went to staples and bought a couple of packages of
refrigerator magnets. i then cut some lengths of steel strapping about 1.5"
long (i used some leftover stuff from vans crating). the baffling has to be
trimmed far enough that the cowling doesn't touch. then place the magnet on
one side of the aluminum baffling and the steel strapping on the other side,
held in place with the magnet, protruding above the baffling edge. do this
every few inches around the baffling. place the cowling on and the cowling
will push the protruding straps down. remove the cowling and measure the
distance from the top of each strap to the top of the cowling. this is your
clearance. trim as required. works great!
doug meloche
rv6
> --> RV6-List message posted by: "Mike Comeaux" <mcomeaux@bendnet.com>
>
> I'm getting baffled on baffeling any good web sites or instructions on how to
> trim to cowling?
> Regards Mike Comeaux
> mcomeaux@bendnet.com
>
>
>
>
>
>
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Last "Official" Day To Make Your List Contribution!! |
--> RV6-List message posted by: Matt Dralle <dralle@matronics.com>
Dear Listers,
Well, its November 30th and that means three things...
1) Today I am officially 40 years old (sympathy is appreciated)!
2) It marks that last "official" day of the List Fund Raiser!
3) Its the last day I will be bugging everyone for a whole year! :-)
If you use the Lists and enjoy the content and the no-advertising, no-spam,
and no-censorship way in which they're run, please make a Contribution
today to support their continued operation and upkeep. Your $20 or $30
goes a long way to further the List operation and keep the bills paid.
A Lister wrote a funny message in the comments field of his Contribution
today that I thought summed up the whole situation:
"Worth every penny and I'm a tightwad!"
Thank you to everyone that has made a Contribution so far this year! It is
greatly appreciated.
Contributions: http://www.matronics.com/contribution
Best regards,
Matt Dralle
Email List Admin.
Matt G Dralle | Matronics | PO Box 347 | Livermore | CA | 94551
925-606-1001 V | 925-606-6281 F | dralle@matronics.com Email
http://www.matronics.com/ WWW | Featuring Products For Aircraft
do not archive
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|