Today's Message Index:
----------------------
1. 05:32 AM - Re: Re: RV6-List Digest: 5 Msgs - 11/17/04 (Charles Heathco)
2. 05:43 AM - Re: Intercom's (Charles Heathco)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: RV6-List Digest: 5 Msgs - 11/17/04 |
--> RV6-List message posted by: "Charles Heathco" <cheathco@comcast.net>
Hiya, no I haven checked that. I went over all conn to see if had a loose
one, and also if any headset jacks loose, found psgr side slightly loose,
tightedn, no help, also took ant conn loose and refit, no help. I will check
for double ground. Could ant be causing this? Someone said trotle cable and
others could act as ant, but they are far away from unit. (ant in wing tip ,
dont know wich one.) Charle
----- Original Message -----
From: <Philippjw54@aol.com>
Subject: RV6-List: Re: RV6-List Digest: 5 Msgs - 11/17/04
> --> RV6-List message posted by: Philippjw54@aol.com
>
> To Charles Heathco,
> Concerning the scratchy noise on rec side of the Kx-125. Have you checked
> that only one end of the shielded wires are grounded? Ground only (1 )
> one end
> of the shielding otherwise you defeat the purpose for the shielding to
> give
> a path for unwanted emf noise (electrical magnetic force) trying to induce
> emf
> to other wiring.
> Regards Philip Wallace RV4 builder
> still
> pushing forward
>
>
>
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
--> RV6-List message posted by: "Charles Heathco" <cheathco@comcast.net>
Mark, dont know if you have seen my posts re engine noise in Rec side of my
kx125. Since you installed and wired your radios yourself thought maybe you
would have some Idea what to look for. I tried putting on a filt cap at
Alternator, no help. Xmit side is clean. Charlie heathco
----- Original Message -----
From: "Mark Kosco" <hooks75@msn.com>
Subject: Re: RV6-List: Intercom's
> --> RV6-List message posted by: "Mark Kosco" <hooks75@msn.com>
>
> The 3000, 4000 etc are great units. But, two seats, cost, functions, easy
> to install, are pluses. I have dual KY-97's, KLN-89B, KT-76A, PM1000II
> installed and wired by me. Works great. But it's up to your wallet.
> Enjoy.
>
> Mark
>
> ----- Original Message -----
> From: Jeff Williams
> To: rv6-list@matronics.com
> Subject: Re: RV6-List: Intercom's
>
> --> RV6-List message posted by: Jeff Williams <Tramsootru@direcway.com>
>
> Actually, the PM3000 is one we have been looking at very closely..
>
> Jeff
> ----- Original Message -----
> From: <ronlee@pcisys.net>
> To: <rv6-list@matronics.com>
> Subject: Re: RV6-List: Intercom's
>
>
>> --> RV6-List message posted by: ronlee@pcisys.net
>>
>> Add to your list the PS Engineering PM3000. I am using the 2000 and am
>> happy with it. The 3000 is apparently better.
>>
>> Ron
>> Lee
>>
>> ---------------------------------------------
>> This message was sent using Endymion MailMan.
>> http://www.endymion.com/products/mailman/
>>
>>
>>
>>
>>
>>
>
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|