Today's Message Index:
----------------------
1. 06:14 AM - Re: Filler for "Unwanted" Rivet Holes ??? (Smcm75@aol.com)
2. 02:39 PM - Re: Filler for "Unwanted" Rivet Holes ??? (J. Brunke)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Filler for "Unwanted" Rivet Holes ??? |
In a message dated 3/26/2009 1:04:26 AM Eastern Daylight Time,
gareywittich2000@yahoo.com writes:
What material have you Builders used to fill in a couple of unwanted holes
in the Skin, where a rivet can NOT be placed to plug the hole ????
Is Super-Fil a possible solution ????
Nope try cutting a little circular patch from .016 aluminum about 3/4" dia.
mix up a small batch of b-2 compound and stick the patch on the hole from the
rear. Then clean the b-2 out of the hole if it oozes in with MEK. After the
b-2 is set up you can fill the hole with featherfill and it will never
vibrate out.
**************Feeling the pinch at the grocery store? Make dinner for $10 or
less. (http://food.aol.com/frugal-feasts?ncid=emlcntusfood00000001)
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Filler for "Unwanted" Rivet Holes ??? |
Ok you got a new one on me. I tried looking up B-2 compound and
couldn't find anything on it. Is this stuff like JB weld?
John
----- Original Message -----
From: Smcm75@aol.com
To: rv6-list@matronics.com
Sent: Thursday, March 26, 2009 7:13 AM
Subject: Re: RV6-List: Filler for "Unwanted" Rivet Holes ???
In a message dated 3/26/2009 1:04:26 AM Eastern Daylight Time,
gareywittich2000@yahoo.com writes:
What material have you Builders used to fill in a couple of unwanted
holes in the Skin, where a rivet can NOT be placed to plug the hole ????
Is Super-Fil a possible solution ????
Nope try cutting a little circular patch from .016 aluminum about 3/4"
dia. mix up a small batch of b-2 compound and stick the patch on the
hole from the rear. Then clean the b-2 out of the hole if it oozes in
with MEK. After the b-2 is set up you can fill the hole with featherfill
and it will never vibrate out.
-------------------------------------------------------------------------
-----
Feeling the pinch at the grocery store? Make dinner for $10 or less.
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|