Today's Message Index:
----------------------
1. 05:28 AM - Re: Canopy frame (cary rhodes)
Message 1
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Canopy frame |
--> RV7-List message posted by: cary rhodes <rhodeseng@yahoo.com>
Tom
I was just there last nite
The 617 and 168 are fiber blocks
They are in one of the bags
The 619 is a 1/4 inch bar of alum.
The one sent with the the tip up kit is about 1 1/4
wide and about 8 inches long.
I didn't want to cut out a chunk of the bar, but I had
a 1/4 angle I whacked up.
I believe the drawing was 47
cary
finish stuff
--- Tom Reading <treading@comcast.net> wrote:
> --> RV7-List message posted by: Tom Reading
> <treading@comcast.net>
>
> Just finished up the linkage to the frame and was
> reading ahead where it
> said to mount the c-617 618 619 blocks. Its most
> likely simple but I can't
> locate the blocks on the prints or spare parts.
> Thanks
> Tom,775TR RES Canopy
>
>
>
> Contributions
> any other
> Forums.
>
> latest messages.
> List members.
>
> http://www.matronics.com/subscription
> http://www.matronics.com/FAQ/RV7-List.htm
> Digests:http://www.matronics.com/digest/rv7-list
> http://www.matronics.com/archives
> http://www.matronics.com/photoshare
> http://www.matronics.com/emaillists
>
>
>
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|