Today's Message Index:
----------------------
1. 09:06 PM - Re: Nutplate Question (Jordan Grant)
Message 1
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Nutplate Question |
--> RV7-List message posted by: "Jordan Grant" <jgrant@sw.rr.com>
I don't have the measurements handy, but here's some sage advice:
Go ahead and pick up your Aircraft Spruce catalog and turn to the
section on nutplates. Order a few of every different configuration,
miniature and full-size, #6 and #8. Some of them are a little expensive,
so just get 10 or 15 of those kind. For the less expensive, you can get
some more. You never know when you'll run into some little job that
would be much easier with a smaller size nutplate, or a corner nutplate,
or a one-ear, etc.... These kinds of things are much more common as you
get into the fuselage and finishing kits. It'll cost you a little bit to
do this, but it will pay for itself if saved frustration.
Good luck,
Jordan Grant
RV-6 Slow Build FWF
N198G Reserved
-----Original Message-----
From: owner-rv7-list-server@matronics.com
[mailto:owner-rv7-list-server@matronics.com] On Behalf Of Richard E.
Tasker
Subject: RV7-List: Nutplate Question
--> RV7-List message posted by: "Richard E. Tasker"
--> <retasker@optonline.net>
I need a #6 or #8 nutplate that is smaller than the standard size.
Does anyone know what the rivet hole spacing is on the miniature
nutplates (MS21069 type)?
Thanks,
Dick Tasker, 90753
Waiting for Fuselage and working on the fiberglass tips
direct advertising on the Matronics Forums.
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|