Today's Message Index:
----------------------
1. 09:21 AM - Re: Riveting F 704-RV-7 (Hopperdhh@AOL.com)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Riveting F 704-RV-7 |
--> RV7-List message posted by: Hopperdhh@aol.com
Cliff,
I think you must have missed something! Yes, rivet on the F704 C & D pieces
to the spar before the skin. I think they should have been put on during
construction of the F704 bulkhead.
While you are at it, now would be the easiest time to install the two fuel
lines that go from the valve to the (enlarged) holes in the skin. It is very
hard to get a good job after the skins are on.
Dan Hopper (Indiana, USA)
RV-7A (almost done)
In a message dated 4/16/04 1:30:24 AM US Eastern Standard Time,
exodus@gds.co.za writes:
>
> --> RV7-List message posted by: "Exodus" <exodus@gds.co.za>
>
> Hi all
> I am getting ready to rivet on the forward fuselage skins (RV-7) but have
> not yet riveted the F 704C and F 704 D centre section side plates to the F 704
> F and E centre section fore and aft bulkheads. I dont remember seeing these
> instructions in the manual. Do I have to wait till later or did I miss
> something.
> Regards
> Cliff Lotter
> South Africa
> Do not archive
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|