Today's Message Index:
----------------------
1. 10:59 AM - RV-7A Rudder ()
2. 11:53 AM - Re: RV-7A Rudder (Charlie England)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
--> RV7-List message posted by: <dfiggins@es.com>
Just a quick question, finishing the rudder installation and the
dimension callout for the 3 rod end bearings appears to put the rudder
at an angle to the VS rather than parallel, as the dimensions increase
from top to bottom, is this correct? Or am I reading the drawing
incorrectly?
Dave Figgins RV-7A (waiting for wings)
Do not archive
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: RV-7A Rudder |
--> RV7-List message posted by: Charlie England <ceengland@bellsouth.net>
dfiggins@es.com wrote:
>--> RV7-List message posted by: <dfiggins@es.com>
>
>Just a quick question, finishing the rudder installation and the
>dimension callout for the 3 rod end bearings appears to put the rudder
>at an angle to the VS rather than parallel, as the dimensions increase
>from top to bottom, is this correct? Or am I reading the drawing
>incorrectly?
>
>Dave Figgins RV-7A (waiting for wings)
>Do not archive
>
It's been a while since I mounted mine, but I think its because the
rudder is tapered (fatter at the bottom) & the spar isn't parallel to
the rolled leading edge.
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|