Today's Message Index:
----------------------
1. 06:42 PM - Re: clearance hole in firewall for nose gear leg bolt (RV-7A) (Imken)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | clearance hole in firewall for nose gear leg bolt (RV-7A) |
--> RV7-List message posted by: "Imken" <skikrazi@CenturyTel.net>
I did not put in a hole in the firewall at all. There was enough clearance.
Chuck Imken
-----Original Message-----
From: owner-rv7-list-server@matronics.com
[mailto:owner-rv7-list-server@matronics.com]On Behalf Of Merems
Subject: RV7-List: clearance hole in firewall for nose gear leg bolt (RV-7A)
--> RV7-List message posted by: "Merems" <merems@cox.net>
Fellow RV-7A builders,
What is the proper size hole to cut in the firewall to gain access to the
nose gear leg bolt. There is a inconsistency in the plans. On the firewall
construction drawing it calls out 3/4" diameter hole and on the nose gear
installation drawing (where the bolt is actually called out) it calls out a
1" diameter hole.
I don't want to put in a larger hole if it is not required.
Paul (RV-7A fuselage)
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|