---------------------------------------------------------- RV7-List Digest Archive --- Total Messages Posted Sun 03/13/05: 1 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 06:42 PM - Re: clearance hole in firewall for nose gear leg bolt (RV-7A) (Imken) ________________________________ Message 1 _____________________________________ Time: 06:42:18 PM PST US From: "Imken" Subject: RE: RV7-List: clearance hole in firewall for nose gear leg bolt (RV-7A) --> RV7-List message posted by: "Imken" I did not put in a hole in the firewall at all. There was enough clearance. Chuck Imken -----Original Message----- From: owner-rv7-list-server@matronics.com [mailto:owner-rv7-list-server@matronics.com]On Behalf Of Merems Subject: RV7-List: clearance hole in firewall for nose gear leg bolt (RV-7A) --> RV7-List message posted by: "Merems" Fellow RV-7A builders, What is the proper size hole to cut in the firewall to gain access to the nose gear leg bolt. There is a inconsistency in the plans. On the firewall construction drawing it calls out 3/4" diameter hole and on the nose gear installation drawing (where the bolt is actually called out) it calls out a 1" diameter hole. I don't want to put in a larger hole if it is not required. Paul (RV-7A fuselage)