---------------------------------------------------------- RV7-List Digest Archive --- Total Messages Posted Fri 09/30/05: 2 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 10:27 AM - Builder assistance available (Bud Newhall) 2. 01:45 PM - Re: Panel cut outs () ________________________________ Message 1 _____________________________________ Time: 10:27:23 AM PST US From: Bud Newhall Subject: RV7-List: Builder assistance available --> RV7-List message posted by: Bud Newhall Greetings You want an RV but don't have the time to build it. I can help. I am a machinist by trade. I completed an RV-6 in 2200 hrs. (no prepunced holes) and assisted on 2 others. I am available to work on a project full time. I am located in Lodi, CA. Bud Newhall RV-6@comcast.net 209-334-2911 ________________________________ Message 2 _____________________________________ Time: 01:45:17 PM PST US From: Subject: Re: RV7-List: Panel cut outs --> RV7-List message posted by: HI Dan where is your web site ? i.perry. ----- Original Message ----- From: "Dan Checkoway" Subject: Re: RV7-List: Panel cut outs > --> RV7-List message posted by: "Dan Checkoway" > >> I am thinking of securing the angles to the panel with c/s screws so I >> could remove and remake them if I wanted to adjust the radio in/out >> position. Not ideal (will see the screws) but that's the compromise to >> keep $10k in my pocket for the time being. > > Good call. I'll be doing the same next time...using screws/nutplates > instead of rivets. > > My current panel can't be removed without doing some surgery (albeit > pretty > minor) on my radio trays. If I had used screws instead of rivets, it > would > be a relatively quick no-brainer to get the panel out. > > Next time -- homemade modular, and screws on the tray supports. > > )_( Dan > RV-7 N714D (622 hours) > http://www.rvproject.com > > >