Today's Message Index:
----------------------
1. 05:32 AM - Re: exp2v bus dc load (Peter DeCraene)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: exp2v bus dc load |
Ilan
The x-bus simply replaces the circuit breakers shown in the wiring diagrams from
Van's. Power to the x-bus is supplied from the alternator to the x-bus the
same as it would be to a bus bar or fuse block. The over current protection is
provided by the x-bus elimanating fuses and breakers with the exception of the
main breaker from the source. x-bus has outputs for each of the loads you
will need to serve. On my panel I removed the switches from the x-bus pc board
so that I could mount the switches in my panel where I wanted them. I have
never had an overload or any condition that would cause the x-bus to trip, but
I did while I was testing things prior to flight and the x-bus worked fine.
I have a couple of pictures of my panel on my web site and I'm sure I have more
if you need them, let me know.
Pete
526PD
http://www.ews.uiuc.edu/~decraene/index.htm
----- Original Message -----
From: i.perry@lipogen.co.il
To: rv7-list@matronics.com
Sent: Wednesday, October 19, 2005 9:08 AM
Subject: Re: RV7-List: exp2v bus dc load
Hi pete !Can you be more accurate regarding integration betweenEXP2v BUS.. and
ESWH7 kits. Thanks Ilan perry.
----- Original Message -----
From: Peter DeCraene
To: rv7-list@matronics.com
Sent: Wednesday, October 19, 2005 12:10 AM
Subject: Re: RV7-List: exp2v bus dc load
we used the x-bus and also bought the electric wiring kit from van's. I was
able to use most of what came with the wiring kit and it served as a good starting
point for the wiring. I t also had some basic wiring diagrams that helped.
I did take the wiring harness apart but used all of the wire, and bought
alot more.
Pete DeCraene
N526PD
----- Original Message -----
From: i.perry@lipogen.co.il
To: rv7-list@matronics.com
Sent: Tuesday, October 18, 2005 3:46 PM
Subject: RV7-List: exp2v bus dc load
Hi !there is anyone with an experience with EXP2VBUS dc load center kit,and
van's -es wh7kit (wire harness).integration between both of kits.Best regards
i.perry.
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|