---------------------------------------------------------- RV7-List Digest Archive --- Total Messages Posted Fri 03/16/07: 1 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 04:52 PM - -7 tipup rollbar question (Charlie England) ________________________________ Message 1 _____________________________________ Time: 04:52:20 PM PST US From: Charlie England Subject: RV7-List: -7 tipup rollbar question I'm fitting the F-631 rollover assy. to the fuselage. If I set the base at the station mentioned on the plans sheet (from memory, 56 13/16"?) it looks like I need to trim F732A about 1/4" to get that 2 7/8" setback at the top. Is there any consensus on this, or have y'all just used the F732A to set the tilt? Thanks, Charlie ------------------------------------------------------------------------------------- Other Matronics Email List Services ------------------------------------------------------------------------------------- Post A New Message rv7-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/RV7-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com Full Archive Search Engine http://www.matronics.com/search 7-Day List Browse http://www.matronics.com/browse/rv7-list Browse Digests http://www.matronics.com/digest/rv7-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution ------------------------------------------------------------------------------------- These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.