Today's Message Index:
----------------------
1. 07:45 PM - Flap actuator push rods (J. Brunke)
2. 09:02 PM - Re: Flap actuator push rods (Herb Feldman)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Flap actuator push rods |
Dear Listers,
On the drawing for the electric flap installation, the F759A, flap pushrod
has to be drilled out to accept a threaded bolt.
It says on my drawing to drill it to #3. A # 3 bit would be kind of large
for this tubing. Can anyone please tell
me the correct bit number?
Thanks,
John Brunke
RV7 tipup (slowly but surely)
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Flap actuator push rods |
A #3 drill is the correct tap drill for 1/4 - 28
thread.
Herb
--- "J. Brunke" <jdoody727@comcast.net> wrote:
> <jdoody727@comcast.net>
>
> Dear Listers,
>
> On the drawing for the electric flap installation,
> the F759A, flap pushrod
> has to be drilled out to accept a threaded bolt.
>
> It says on my drawing to drill it to #3. A # 3 bit
> would be kind of large
> for this tubing. Can anyone please tell
> me the correct bit number?
>
> Thanks,
> John Brunke
> RV7 tipup (slowly but surely)
>
>
>
> browse
> Subscriptions page,
> FAQ,
> http://www.matronics.com/Navigator?RV7-List
>
> Web Forums!
>
>
>
>
>
__________________________________________________
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|