Today's Message Index:
----------------------
1. 06:14 AM - Re: RV7-List Digest: 2 Msgs - 03/25/08 (User &)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: RV7-List Digest: 2 Msgs - 03/25/08 |
On Tue, 25 Mar 2008 23:57:41 -0700, RV7-List Digest Server wrote>
> We didnt have any problems with the piston installation by just
> following the directions.
>
> The one thing I do notice is the minor flexing of the side rails
> when the canopy is opened and you let go if it that last 6 inches or
> so when the piston takes over and pushes it up. Increasing the
> rigidity of the side rails would be a good idea however there is not
> much access as there is barely enough room to get your fingers in
> there to place the nut for the support block so I dont see how you
> can get any foam and fiberglass in there.
>
J Brunke and others,
Use plate{anchor nuts} as the winged ears will corner out and eliminate
the need to hold on a wrench for tightning. Make a little 90 degree wire
tool to slide the plate nut over the screw whole.
Kelly Landrum
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|