Today's Message Index:
----------------------
1. 05:44 AM - F-6111-L&R Stiffeners (Merrill D. Evans)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | F-6111-L&R Stiffeners |
Here's some of the best advice I ever read. Unfortunately, I didn't read
it until I messed up my first F-6111. Works like a charm! I found it on
VAF.
First don't cut them shorter! draw a center line down the flange, then
trim the bottom edge to fit the longeron, the top flange needs a long
taper trimed to fit the bulkhead. Hold the rib tight to the longeron set
the line in the holes and start drilling and clecoing from the bottom to
the top. it looks like no way but it will go right in and is realy easy.
no fluting needed just a slight twist to get the top to fit the bulkhead
tight
good luck
Frank
-------------------------------------------------------------------------
-------
Last edited by FrankK90989
Regards, Merrill Evans, RV-7 (wings & fuselage), N87EM (reserved)
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|