Today's Message Index:
----------------------
1. 04:46 PM - Re: Elevator Horn Weldment - Installation (Brian Gawronski)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | RE: Elevator Horn Weldment - Installation |
Garey,I'm at the same point building the right elevator for my -7. -Same
parts as the -8 according to my Drawing 4PP Rev 2. -As near as I can meas
ure, the angle is 66 degrees on everything, meaning both left and right ele
v. horns, and the angle the spar makes to the root rib when mated to the sk
in. -Are you measuring 70 degrees with the spar and root rib in position
on the skin? -It's the skin that sets the angle between the spar and the
root rib.To make the horn fit tight to both the spar and the root rib, I ne
eded to file the end of the spar at the apex of the angle, as mentioned in
the plans. -I have an early -7 kit, though I don't think much about the e
levator has been changed since the -7 was introduced. -As of yesterday, n
ot all the parts have been pre-punched. -How do I know? -I just had to
place an order to replace the tip ribs, and pre-punched E-604s and E-605s a
re not available from "the list".-Hope this helps.Brian=0A=0A=0A
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|