Today's Message Index:
----------------------
1. 03:56 PM - FS: RV-7A ~80% complete (Brian Meyette)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | FS: RV-7A ~80% complete |
I've decided to sell my RV-7A project. It's just dragged on and on, and I've
lost interest in completing it. I have more interest in just flying my
Challenger II. I made 75 flights in it in 2009.
Engine is Subaru WRX STi 2.5 L supercharged. All the bugs are worked out of
the original Eggenfellner product. Most Eggenfellner-supplied components
have been replaced; SDS ECU, custom radiators, new wiring harness,
supercharger gearing. Engine runs great, and all it needs is probably some
more fine-tuning of the SDS ECU. John Moody in Australia has been flying his
awhile. Includes latest Gen3 rev 4 PSRU, installed. Includes MT7 electric
prop, installed.
Three EFIS systems installed - Blue Mountain "gold box" EFIS/One, GRT
Horizon, and Dynon D10. Blue Mountain AP installed. GRT EIS installed
Full Garmin stack trays installed & SL-30 included. Sandia TSOd encoder,
Tipup canopy completed but not final-installed.
Needs rear window installed, 1 panel each wing installed, top fuse panel
behind window and fwd of canopy installed (left out for wiring access). No
fiberglass work done.
Includes Advanced Flight Systems AoA, wig-wag HID lights, bulletproof
electrical system based on Bob Nuckolls' designs and Hyperion products, low
fuel warning, low coolant warning, fuel pressure warning, electric flaps,
electric trim, custom console, heater, Oregon Aero seats, Hooker harness,
Show Planes Flaps Positioning System, Infinity Aerospace grips, cabin
lighting, custom baggage compartment and other customizations (see my custom
page http://www.meyette.us/custom.htm ). Includes finishing kit and all
parts (except remaining Garmin components) to finish it. All gear mounted
and brakes installed. Van's front gear leg SB installed. Panel complete,
except Garmin wiring.
Empennage is done & final-installed. Flaps & ailerons all done. Wings not
installed.
And much more - this is a list off the top of my head of some of the main
components.
Entire project very extensively documented at
http://www.meyette.us/RV-7Ahome.htm
No effort or expense spared in doing everything RIGHT.
Only asking $45k for it - way less than cost and making the FWF essentially
FREE. Will also trade for an RV-12
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|