Today's Message Index:
----------------------
1. 07:08 PM - Stiff slider on RV9 (Richard E. Tasker)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Stiff slider on RV9 |
I am having difficulty with the canopy on my 9A. What happens is that it is essentially
impossible to start it sliding from the closed position.
I thought it was the rear pin blocks that were binding, but it does the same thing
with them completely removed.
If I am inside, I can get it started by slightly pushing up on the rear. From the
outside, the only way is to pull up on the rear. Since the canopy rear skirts
are not yet installed that is now
possible, but when they are installed it will be impossible. Once I get it to move
about 1/2 - 1 inch, then it moves back easily.
I have checked everything I can think of and everything seems to be spot on, but
I am obviously missing something.
Has anyone run into this problem? Does anyone have suggestions as to what I should
look for?
Dick Tasker
--
Please Note:
No trees were destroyed in the sending of this message. We do concede, however,
that a significant number of electrons may have been temporarily inconvenienced.
--
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|