Today's Message Index:
----------------------
1. 03:23 PM - RV-8 electric trim (James Gray)
2. 04:53 PM - Re: RV-8 electric trim (Paul Petty)
Message 1
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | RV-8 electric trim |
--> RV8-List message posted by: James Gray <n747jg@earthlink.net>
I'm just about to finish my left elevator on my RV-8 and want to think this
thru before I close up the elevator and bend the leading edge. I'm
guessing that it would be OK to run the wires from the motor thru the hole
in the elevator spar for the manual trim cable, into the stab thru that
manual cable hole and into the fuselage using some type of protective wrap
around the wires. Is there a common method that is used that someone can
can pass along?
Jim Gray
RV-8QB
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: RV-8 electric trim |
--> RV8-List message posted by: "Paul Petty" <ppetty@c-gate.net>
Hi Jim,
Just a heads up! My father-n-law hit a snag when his RV8 was being converted
from the panel switch type control for the electric trim to a stick mounted
switch. They had to incorporate a relay and other wiring to make it work so
if you plan to use a stick mounted trim switch may want to change out the
servo before sewing up the elevator..
Just a idea.
PP....
N4958P
----- Original Message -----
From: "James Gray" <n747jg@earthlink.net>
Subject: RV8-List: RV-8 electric trim
> --> RV8-List message posted by: James Gray <n747jg@earthlink.net>
>
> I'm just about to finish my left elevator on my RV-8 and want to think
this
> thru before I close up the elevator and bend the leading edge. I'm
> guessing that it would be OK to run the wires from the motor thru the
hole
> in the elevator spar for the manual trim cable, into the stab thru that
> manual cable hole and into the fuselage using some type of protective wrap
> around the wires. Is there a common method that is used that someone can
> can pass along?
>
> Jim Gray
>
> RV-8QB
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|