----------------------------------------------------------
                           RV8-List Digest Archive
                                      ---
                     Total Messages Posted Fri 12/06/02: 3
           ----------------------------------------------------------
 
 
Today's Message Index:
----------------------
 
     1. 08:13 AM - Re: RV-8 electric trim  (Rob Miller)
     2. 05:15 PM - rv8 fuse. width  (Dr. Kevin P. Leathers)
     3. 05:35 PM - Re: rv8 fuse. width  (James Freeman)
 
 
 
________________________________  Message 1  _____________________________________


Time: 08:13:08 AM PST US
From: Rob Miller <rmill2000@yahoo.com>
Subject: Re: RV8-List: RV-8 electric trim

--> RV8-List message posted by: Rob Miller <rmill2000@yahoo.com>

James

I used a plastic "snap" grommet in those holes and put some shrink tube
over the wires as extra protection.

Good Luck

Rob Miller
N262RM -8 "Bad Cat" 14 hours


--- James Gray <n747jg@earthlink.net> wrote:
> --> RV8-List message posted by: James Gray <n747jg@earthlink.net>
> 
> I'm just about to finish my left elevator on my RV-8 and want to think
> this
> thru before I close up the elevator and bend the leading edge.  I'm
> guessing that it would be OK to run the wires from the motor thru  the
> hole
> in the elevator spar for the manual trim cable, into the stab thru that
> manual cable hole and into the fuselage using some type of protective
> wrap
> around the wires.  Is there a common method that is used that someone
> can
> can pass along?
> 
> Jim Gray
> 
> RV-8QB
> 
> 
>
> 
> 
> 
> 






________________________________  Message 2  _____________________________________


Time: 05:15:44 PM PST US
From: "Dr. Kevin P. Leathers" <DrLeathers@822heal.com>
Subject: RV8-List: rv8 fuse. width

--> RV8-List message posted by: "Dr. Kevin P. Leathers" <DrLeathers@822heal.com>

Hi Guys,

Who can tell me how wide the widest point of an assembled RV8 fuselage is? I'm
trying to decide if I'll be able to get it out of my shop without cutting a new
door or something. I want to build my wings and tail and fuselage in my workshop,
then take everyting to my hanger for final assembly etc.

DOC






________________________________  Message 3  _____________________________________


Time: 05:35:27 PM PST US
Subject: Re: RV8-List: rv8 fuse. width
From: James Freeman <flyeyes@bellsouth.net>

--> RV8-List message posted by: James Freeman <flyeyes@bellsouth.net>


On Friday, December 6, 2002, at 07:12  PM, Dr. Kevin P. Leathers wrote:
>
> Who can tell me how wide the widest point of an assembled RV8 fuselage 
> is?  <snip>_

About 36" at the widest point on the firewall. Figure on a little more 
than this for the "false spars" which make very convenient handles for 
a support frame,  Mine is about 44" total, but I wasn't concerned about 
width since the narrowest door I'll take it through is an 8' garage 
door.

JFF