Today's Message Index:
----------------------
1. 07:20 PM - engine baffling RV6 S-cowl (Dave Ford)
Message 1
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | engine baffling RV6 S-cowl |
--> RV8-List message posted by: "Dave Ford" <dford@michweb.net>
I'm working on engine baffling and wondering specifically how at the front of the
engine between the starter ring gear and the upper/lower cowl joint the distance
that the part 1 fits forward of the aft end of the cowl joint? Should it
be cut off even with the cowl joint so that the fabric will seal that gap?
What about the cowl joint screws rubbing/chaffing against the aluminum or fabric
(depending which method used)? The part supplied in the generic baffle kit
extends forward of the aft end of the cowl air inlet. Should the airseal fabric
seal the whole area around this area with no leaks? It seems this is a hard
area to seal with the fiberglass air inlets being bonded to the cowl meeting
at this area also. Surely someone has been there. Thanks.
Dave Ford
RV6
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|