---------------------------------------------------------- RV8-List Digest Archive --- Total Messages Posted Tue 05/13/03: 2 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 04:26 AM - Re: Re Roll bar (PSILeD@aol.com) 2. 08:06 PM - Re: Re Roll bar (Larry Bowen) ________________________________ Message 1 _____________________________________ Time: 04:26:30 AM PST US From: PSILeD@aol.com Subject: Re: RV8-List: Re Roll bar --> RV8-List message posted by: PSILeD@aol.com Look at the builders hints in the RV White pages. There are pictures of a simple way to correct the problem. I am going to use this method. Paul ________________________________ Message 2 _____________________________________ Time: 08:06:43 PM PST US From: "Larry Bowen" Subject: RE: RV8-List: Re Roll bar --> RV8-List message posted by: "Larry Bowen" Look at this: http://bowenaero.com/pix/rollbar.jpg - Larry Bowen Larry@BowenAero.com http://BowenAero.com 2003 - The year of flight! > --- colin jordan wrote: > > > > --> RV8-List message posted by: "colin jordan" > > > > Thanks Larry and Paul, > > I guess I did not explain my self well, I too only have about a 1/4 > > inch of play when I put the roll bar on the fuselage. The > 24" was just > > a convenient place to measure on the roll bar and the 32" > was to the > > outside of the fuselage.That said it would appear that the > roll bar is > > the piece I need to work on. Larry I am curious how you used the > > engine hoist to spread your roll bar , I have tried the > approved Van's > > method but neither my back nor my muscles were up to the job!