Today's Message Index:
----------------------
1. 05:50 AM - Signing off for OSH (Jack Textor)
2. 06:02 AM - Re: Riveting the HS Skin to the HS607 Tip Rib (Chris Stone)
Message 1
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Signing off for OSH |
--> RV8-List message posted by: Jack Textor <Jack@personnelincorporated.com>
Getting ready to head to OSH, Hope to see you all Tuesday at 9:00 in the
woods!
Jack Textor
RV8
Des Moines
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Riveting the HS Skin to the HS607 Tip Rib |
--> RV8-List message posted by: "Chris Stone" <Chris.Stone@a-dec.com>
Per Van's recommendation... Make a clamp from 3/4" ply that approximates
an old fashioned one piece clothespin. Be careful not to accidentally
deform the skin by forcing it against the rib flange. I bent the rib
flange slightly so that it mates flush with the skin at the leading
edge.
Chris Stone
RV-8 wings...
-----Original Message-----
From: Garey Wittich [mailto:gareywittich2000@yahoo.com]
Subject: RV8-List: Riveting the HS Skin to the HS607 Tip Rib
--> RV8-List message posted by: Garey Wittich
--> <gareywittich2000@yahoo.com>
Any helpful suggestions on how to hold the Horizontal Stabilizer Skin
flat against the flange of the HS607 Tip Rib, when riveting the rivet
closest to the leading edge ? When looking down the interior of the
leading edge of the skin there is a slight air gap (approx1/16") between
the skin and the flange of the HS607.
Garey Wittich Santa Monica, Calif (310) 392-1682
---------------------------------
Free online calendar with sync to Outlook(TM).
direct advertising on the Matronics Forums.
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|