---------------------------------------------------------- RV8-List Digest Archive --- Total Messages Posted Fri 12/12/03: 2 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 04:48 PM - RV-8 Wire Conduit holes through front and rear spars (Vince Himsl) 2. 11:09 PM - Comm and Transponder antennae location (Vincent Himsl) ________________________________ Message 1 _____________________________________ Time: 04:48:56 PM PST US From: "Vince Himsl" Subject: RV8-List: RV-8 Wire Conduit holes through front and rear spars --> RV8-List message posted by: "Vince Himsl" Hello, I am starting to wire my RV-8 and would like to make a cable run that parallels the rudder cables through both the front and rear spar so as to avoid exposed cables in the cabin. This requires my putting two small holes (7/16 to 5/8) a couple inches inboard from each rudder cable spar hole on both front and rear spars. Surfing the net I have seen pictures of where other builders have done same, but would like to hear from anyone who has done this and also has received the official blessing from Van's? Thanks! Vince Himsl RV8-SB Finish N8432 reserved ________________________________ Message 2 _____________________________________ Time: 11:09:31 PM PST US From: "Vincent Himsl" Subject: RV8-List: Comm and Transponder antennae location --> RV8-List message posted by: "Vincent Himsl" Hello, I would like to know where others have placed their Comm and Transponder andtenae. Specifically those who have placed them in easily accessible areas such as uder the front foot wells and near the first bulkhead behind the back seat (RV8). Naturally, I have already placed sound proofing stuff all over and will need to remove some of it. Thanks, Vince Himsl RV8 - SB Finish N8432 reserved