Today's Message Index:
----------------------
1. 06:29 AM - Fw: pneumatic rivet squeezer (Cy Galley)
2. 11:58 AM - Re: Comm and Transponder antennae location (Jack Blomgren)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
<rv3-list@matronics.com>, <rv-list@matronics.com>, <rv7-list@matronics.com>,
<RV10@yahoogroups.com>, <rv10-list@matronic.com>
| Subject: | Fw: pneumatic rivet squeezer |
SUSPICIOUS_RECIPS
--> RV8-List message posted by: "Cy Galley" <cgalley@qcbc.org>
> > I have pneumatic rivet squeezer on eBay.
> >
> > http://tinyurl.com/y6ih
> >
> > Thanks.
> >
> > Dave DeWinter
> > Former RV6 builder and owner
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Comm and Transponder antennae location |
--> RV8-List message posted by: "Jack Blomgren" <jackanet@hotmail.com>
Vince,
An experienced builder in our Twin Cities RV Wing suggested I place mine
both at station 48, one 2 1/2 to 3.0 inches in from the left side and the
other antenna same distance in from the right side. (Station 48 is the
near meeting place of the foot wells floor with the rear floor.) I might
fudge an inch forward to allow straight downward drilling of the two
antenna feed through holes.
Best Regards, Jack
>From: "Vincent Himsl" <vhimsl@turbonet.com>
>Reply-To: rv8-list@matronics.com
>To: <rv8-list@matronics.com>
>Subject: RV8-List: Comm and Transponder antennae location
>Date: Fri, 12 Dec 2003 23:07:15 -0800
>
>--> RV8-List message posted by: "Vincent Himsl" <vhimsl@turbonet.com>
>
>Hello,
>
>I would like to know where others have placed their Comm and Transponder
>andtenae. Specifically those who have placed them in easily accessible
>areas such as uder the front foot wells and near the first bulkhead behind
>the back seat (RV8).
>
>Naturally, I have already placed sound proofing stuff all over and will
>need
>to remove some of it.
>
>Thanks,
>Vince Himsl
>RV8 - SB Finish
>N8432 reserved
>
>
Dont worry if your Inbox will max out while you are enjoying the holidays.
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|