----------------------------------------------------------
                           RV8-List Digest Archive
                                      ---
                     Total Messages Posted Sun 12/14/03: 2
           ----------------------------------------------------------
 
 
Today's Message Index:
----------------------
 
     1. 06:29 AM - Fw: pneumatic rivet squeezer   (Cy Galley)
     2. 11:58 AM - Re: Comm and Transponder antennae location  (Jack Blomgren)
 
 
 
________________________________  Message 1  _____________________________________


Time: 06:29:28 AM PST US
From: "Cy Galley" <cgalley@QCBC.ORG>
   <rv3-list@matronics.com>, <rv-list@matronics.com>, <rv7-list@matronics.com>,
   <RV10@yahoogroups.com>, <rv10-list@matronic.com>
Subject: RV8-List: Fw: pneumatic rivet squeezer 
 SUSPICIOUS_RECIPS

--> RV8-List message posted by: "Cy Galley" <cgalley@qcbc.org>


> > I have pneumatic rivet squeezer on eBay.
> > 
> > http://tinyurl.com/y6ih
> > 
> > Thanks.
> > 
> > Dave DeWinter
> > Former RV6 builder and owner






________________________________  Message 2  _____________________________________


Time: 11:58:46 AM PST US
From: "Jack Blomgren" <jackanet@hotmail.com>
Subject: RE: RV8-List: Comm and Transponder antennae location

--> RV8-List message posted by: "Jack Blomgren" <jackanet@hotmail.com>

Vince,

An experienced builder in our Twin Cities RV Wing suggested I place mine 
both at station 48, one 2 1/2 to 3.0 inches in from the left side and the 
other antenna  same  distance in from the right side.  (Station 48 is the 
near meeting place of the foot wells floor with the rear floor.)  I might 
fudge an inch forward to allow straight  downward drilling of the two 
antenna feed through holes.

Best Regards, Jack
>From: "Vincent Himsl" <vhimsl@turbonet.com>
>Reply-To: rv8-list@matronics.com
>To: <rv8-list@matronics.com>
>Subject: RV8-List: Comm and Transponder antennae location
>Date: Fri, 12 Dec 2003 23:07:15 -0800
>
>--> RV8-List message posted by: "Vincent Himsl" <vhimsl@turbonet.com>
>
>Hello,
>
>I would like to know where others have placed their Comm and Transponder
>andtenae.  Specifically those who have placed them in easily accessible
>areas such as uder the front foot wells and near the first bulkhead behind
>the back seat (RV8).
>
>Naturally, I have already placed sound proofing stuff all over and will 
>need
>to remove some of it.
>
>Thanks,
>Vince Himsl
>RV8 - SB Finish
>N8432 reserved
>
>

Dont worry if your Inbox will max out while you are enjoying the holidays.