----------------------------------------------------------
                           RV8-List Digest Archive
                                      ---
                     Total Messages Posted Mon 01/12/04: 1
           ----------------------------------------------------------
 
 
Today's Message Index:
----------------------
 
     1. 02:58 PM - Fuel Primer Aluminum 3003-0 tubing  (Vince Himsl)
 
 
 
________________________________  Message 1  _____________________________________


Time: 02:58:48 PM PST US
From: "Vince Himsl" <vhimsl@turbonet.com>
Subject: RV8-List: Fuel Primer Aluminum 3003-0 tubing

--> RV8-List message posted by: "Vince Himsl" <vhimsl@turbonet.com>

Hello,

I have an Aerosport engine that was shipped with the superior air parts stainless
steel primer lines and brass fittings
(not installed). I am trying to complete the installation but am confused as to
the type of tubing to get to run from the
brass tee at engine (requires the AN800-2 cone fitting and nut) to the wicks/primer
solenoid on the firewall.

I was going to use aluminum 3003-0 tubing but am unsure as to suitability with
the cone kit sold by Wicks and Spruce.

In short, has anyone used the 3003 aluminum tubing from the engine to the primer
solenoid/pump and if so, how did you
attach the an800-2 union cone (pg 109 Spruce 2003 cat.) 

My fall back is copper but would like to go with aluminum if possible.

Pictures welcome.

Thanks!

Vince Himsl
RV-8 SB Finish