Today's Message Index:
----------------------
1. 03:25 AM - Re: landing gear bracket fit issue (RV8ter@aol.com)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: landing gear bracket fit issue |
--> RV8-List message posted by: RV8ter@aol.com
Thanks. Is there general agreement that the 3/16 edge distance from the
side of the fuselage to the outer wear bracket isn't enough to avoid washer/nut
clearance issues on the inside of the fuselage? I think Randy Lervold
suggested 3/8 was a more practical.
In a message dated 1/24/2004 9:53:31 PM Eastern Standard Time,
sclarkson@tellurian.net writes:
--> RV8-List message posted by: "Scott Clarkson" <sclarkson@tellurian.net>
(Un)Lucky,
If my memory serves me correctly and since the plane was sitting high enough
off of the floor I think I crawled under the plane and put my Smartlevel
directly of the floor skin to level it. This made quite a difference in my
case and the gear fell in where they should be.
Scott Clarkson
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|