---------------------------------------------------------- RV8-List Digest Archive --- Total Messages Posted Mon 03/01/04: 4 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 05:15 AM - VM 1000 & Single Drive Dual Mag (DLN 3000) (Esten Spears) 2. 05:24 AM - VM 1000 Fuel Flowmeter & Purge Valve Installation (Esten Spears) 3. 11:47 AM - Re: (Richard Lundin) 4. 06:55 PM - skis (Mike Betti) ________________________________ Message 1 _____________________________________ Time: 05:15:34 AM PST US From: "Esten Spears" Subject: RV8-List: VM 1000 & Single Drive Dual Mag (DLN 3000) --> RV8-List message posted by: "Esten Spears" Has anyone installed a VM 1000 Engine Monitor with a Single Drive Dual Mag? If So; What Tach Sensor did you use and where and how did you mount it?????? The instructions call for it to be placed in the gear inspection port where it picks up the passing gear teeth. The single drive dual mag has such ports but it uses nylon gears so I don't think the sensor would see anything. Any help would be appreciated! Esten Spears, RV8A, 80922, N922ES (reserved), Leeward Air Ranch, Ocala, FL ________________________________ Message 2 _____________________________________ Time: 05:24:45 AM PST US From: "Esten Spears" Subject: RV8-List: VM 1000 Fuel Flowmeter & Purge Valve Installation --> RV8-List message posted by: "Esten Spears" Has anyone done an IO 360 200HP with a VM 1000 Fuel Flowmeter & Purge Valve Installation??? If so; where and how did you place the purge valve and flowmeter????? I am using standard Bendix Servo and Spider. Any help would be appreciated!! Esten Spears, RV8A, 80922, N922ES (reserved), Leeward Air Ranch, Ocala, FL ________________________________ Message 3 _____________________________________ Time: 11:47:24 AM PST US From: Richard Lundin Subject: Re: RV8-List: --> RV8-List message posted by: Richard Lundin I worked with RTV alot in boat work some years ago. I don't know of anything that breaks it down. We use to get things loose by applying moderate pull, in this case on the fairing, and then use a razor knife to cut the RTV loose in several passes. Keep the pull light to moderate and you should be fine. Rick --- rdaulton3@comcast.net wrote: > --> RV8-List message posted by: > > > Help..Help...A previous owner used RTV to seal the > fairing around the vertical fin/horizontal stab. > Can anyone tell me what will remove the RTV. It is > the rubber compound used to seal around bathtubs, > ect. Thanks much in advance. > rdaulton3@comcast.net. > > > > Contributions > any other > Forums. > > http://www.matronics.com/chat > > http://www.matronics.com/subscription > http://www.matronics.com/FAQ/RV8-List.htm > http://www.matronics.com/archives > http://www.matronics.com/photoshare > http://www.matronics.com/emaillists > > > > > __________________________________ http://antispam.yahoo.com/tools ________________________________ Message 4 _____________________________________ Time: 06:55:06 PM PST US From: "Mike Betti" Subject: RV8-List: skis --> RV8-List message posted by: "Mike Betti" Has any one set up a RV8 with skis? I'm thinking of building one in the future and would require them. Mike