Today's Message Index:
----------------------
1. 10:44 PM - Use a special Bucking Bar inside the HS ? (Garey Wittich)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Use a special Bucking Bar inside the HS ? |
--> RV8-List message posted by: Garey Wittich <gareywittich2000@yahoo.com>
There is not much space "inside" the Horiz Stabilizer
Assy to hold a Bucking Bar against the Rivet closed to
the leading edge of the inner most Rib (HS607), as I
reach my arm inside. Did you use a special Bucking
Bar? It seems like a "hit and miss" situation to get
a good shop head on this rivet, as it is done by
Braille. If one screws up, it seems to me it would be
difficult to drill it out without doing damage. Any
helpfull ideas ? Did you use a "Pop Rivet" because of
accessability ? If so what was it. All Skins and
Ribs are dimpled for a -3 Rivet, so a CS4-4 ( 4/32 )
is too big in diameter.
Thanks, Garey RV-8A QB Kit Santa Monica, CA
__________________________________
http://search.yahoo.com
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|