Today's Message Index:
----------------------
1. 03:46 PM - Re: RV-8 flap motor rubs (Greg V. Miller)
2. 09:45 PM - Re: RV-8 flap motor rubs (Maureen & Bob Christensen)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: RV-8 flap motor rubs |
--> RV8-List message posted by: "Greg V. Miller" <gvm@cableone.net>
Mine too. I put clear plastic packing tape on both surfaces and just let
them rub. 350 hours, no worries...
On Sat, 2004-05-15 at 16:06, GEORGE INMAN wrote:
> --> RV8-List message posted by: "GEORGE INMAN" <ghinman@allstream.net>
>
> I am installing my flap motor,
> on my RV-8 quick build,
> and have a problem with the flap motor
> rubbing on the F-876PP-L aft cabin cover.
> I may need another 1/4" clearance.
> I have not yet installed the wings
> and flaps.
> Have others had this problem?
> And if so how did they fix it?
>
> GEORGE H. INMAN
> ghinman@allstream.net
>
>
>
>
>
>
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: RV-8 flap motor rubs |
--> RV8-List message posted by: "Maureen & Bob Christensen" <mchriste@danvilletelco.net>
They talk about this on the tapes . . . and suggest putting the nutplates on
the floor out (in) a little to accommodate for this?! I'm about to this
point but haven't wrestled with it yet.
Regards,
Bob Christensen
----- Original Message -----
From: "GEORGE INMAN" <ghinman@allstream.net>
Subject: RV8-List: RV-8 flap motor rubs
> --> RV8-List message posted by: "GEORGE INMAN" <ghinman@allstream.net>
>
> I am installing my flap motor,
> on my RV-8 quick build,
> and have a problem with the flap motor
> rubbing on the F-876PP-L aft cabin cover.
> I may need another 1/4" clearance.
> I have not yet installed the wings
> and flaps.
> Have others had this problem?
> And if so how did they fix it?
>
> GEORGE H. INMAN
> ghinman@allstream.net
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|