----------------------------------------------------------
                           RV8-List Digest Archive
                                      ---
                     Total Messages Posted Tue 05/18/04: 2
           ----------------------------------------------------------
 
 
Today's Message Index:
----------------------
 
     1. 03:46 PM - Re: RV-8 flap motor rubs  (Greg V. Miller)
     2. 09:45 PM - Re: RV-8 flap motor rubs  (Maureen & Bob Christensen)
 
 
 
________________________________  Message 1  _____________________________________


Time: 03:46:49 PM PST US
Subject: Re: RV8-List: RV-8 flap motor rubs
From: "Greg V. Miller" <gvm@cableone.net>

--> RV8-List message posted by: "Greg V. Miller" <gvm@cableone.net>

Mine too. I put clear plastic packing tape on both surfaces and just let
them rub. 350 hours, no worries...


On Sat, 2004-05-15 at 16:06, GEORGE INMAN wrote:
> --> RV8-List message posted by: "GEORGE INMAN" <ghinman@allstream.net>
> 
>          I am installing my flap motor,
>   on my RV-8  quick build,
>  and have a problem with the flap motor
>  rubbing on the F-876PP-L  aft cabin cover.
>  I may need another 1/4" clearance.
>                I have not yet installed the wings
>  and flaps.
>              Have others had this problem?
>   And if so how did they fix it?
> 
> GEORGE H. INMAN
> ghinman@allstream.net
> 
> 
> 
> 
> 
> 






________________________________  Message 2  _____________________________________


Time: 09:45:54 PM PST US
From: "Maureen & Bob Christensen" <mchriste@danvilletelco.net>
Subject: Re: RV8-List: RV-8 flap motor rubs

--> RV8-List message posted by: "Maureen & Bob Christensen" <mchriste@danvilletelco.net>

They talk about this on the tapes . . . and suggest putting the nutplates on
the floor out (in) a little to accommodate for this?!  I'm about to this
point but haven't wrestled with it yet.

Regards,
Bob Christensen


----- Original Message ----- 
From: "GEORGE INMAN" <ghinman@allstream.net>
Subject: RV8-List: RV-8 flap motor rubs


> --> RV8-List message posted by: "GEORGE INMAN" <ghinman@allstream.net>
>
>          I am installing my flap motor,
>   on my RV-8  quick build,
>  and have a problem with the flap motor
>  rubbing on the F-876PP-L  aft cabin cover.
>  I may need another 1/4" clearance.
>                I have not yet installed the wings
>  and flaps.
>              Have others had this problem?
>   And if so how did they fix it?
>
> GEORGE H. INMAN
> ghinman@allstream.net
>
>