Today's Message Index:
----------------------
1. 01:30 PM - Floor insulation (PPlous@aol.com)
2. 02:00 PM - Re: Floor insulation (Scott Bilinski)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Floor insulation |
--> RV8-List message posted by: PPlous@aol.com
Anyone using any insulation under the 830/831 floor before riveting the
thing down? If so, what type?
Thanks
P2
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Floor insulation |
--> RV8-List message posted by: Scott Bilinski <bilinski@kyocera-wireless.com>
The best thing to do is to make it air tight so you do not have cold drafts
blowing through. Block the read spar attach, front spars, also boots on the
aileron tubes. This will make a bigger difference IMHO.
At 04:30 PM 12/13/2004 -0500, you wrote:
>--> RV8-List message posted by: PPlous@aol.com
>
>Anyone using any insulation under the 830/831 floor before riveting the
>thing down? If so, what type?
>
>Thanks
>P2
>
>
Scott Bilinski
Eng dept 305
Phone (858) 657-2536
Pager (858) 502-5190
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|