Today's Message Index:
----------------------
1. 01:49 PM - Mounting Radios (Bob C.)
2. 02:32 PM - Re: Mounting Radios (Walter Tondu)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
--> RV8-List message posted by: "Bob C. " <flyboy.bob@gmail.com>
I'm ready to mount my GNS430, Transponder, and Audio Panel.
They look like they'll stick out quite a ways . . . looks like it
would be nice to set them back in the panel . . . not quite flush . .
. what has been the best solution for mounting radio equipment . . .
the traditional way or set back into the panel.
Looks like it would be easier the "traditional way"?
Thanks,
Bob Christensen - N678RC
RV-8 Bldr SE Iowa
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Mounting Radios |
--> RV8-List message posted by: Walter Tondu <walter@tondu.com>
On 04/18 3:45, Bob C. wrote:
> --> RV8-List message posted by: "Bob C. " <flyboy.bob@gmail.com>
>
> I'm ready to mount my GNS430, Transponder, and Audio Panel.
>
> They look like they'll stick out quite a ways . . . looks like it
> would be nice to set them back in the panel . . . not quite flush . .
> . what has been the best solution for mounting radio equipment . . .
> the traditional way or set back into the panel.
Mine stick out (all of them) exactly 3/10th of an inch, just shy
of the bezel width. It was pretty easy to fabricate the mounts.
I think it looks ok. I assume that mounting "methods" are similar
for 8's and 7's, but I could be wrong, don't know much about 8's.
see entry dated 7/3/04
http://rv7-a.com/avionics.htm
Finished Results
http://rv7-a.com/Img_5172.jpg
--
Walter Tondu
http://www.rv7-a.com
Ready to move to airport
Looking for a trailer...
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|