Today's Message Index:
----------------------
1. 03:09 PM - Re: Running VOR coax cable thru VS ()
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Running VOR coax cable thru VS |
garey, drill forward of the forward spar....It will interfer with the rudder otherwise..You
only have that first 6 inches or so with a fiberglass cap...
---- Garey Wittich <gareywittich2000@yahoo.com> wrote:
>
> Ready to drill hole in VS ribs (Top and Middle ribs)
> to run VOR coax cable thru them for cat-wisker VOR
> type antenna mounted on top of VS.
>
> Where have you Builders drilled the hole for the coax
> on the ribs - middle of ribs, on the rib closer to the
> Front Spar or on the rib closer to the Rear Spar ???
> Was a doubler plate used on the ribs, with the coax
> holes, to make up for the the ribs loss of structural
> strength ??
>
> On the bottom rib, it has 3 lightening holes that
> would allow the coax to run thru one of them into the
> fuselage - correct ???
>
> Thanks, Garey
>
>
>
>
>
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|