Today's Message Index:
----------------------
1. 01:03 PM - FLUTING Ribs to match desired taper of VS (Garey Wittich)
2. 07:02 PM - gis-air or x-pak strobe plsu vans fiberglass extensions (Vince-Himsl)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | FLUTING Ribs to match desired taper of VS |
Greetings:
Have an '"older" empennage and instructions dating
back to 1999. Understand RV-7, 8 and 9 have the same
Vert Stabilizer. Is there anything in the "Newer
Instructions" about about tapering (angling) the
flanges of the VS Ribs to match the desired contour
(taper) of the VS ???
Thanks, Garey
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | gis-air or x-pak strobe plsu vans fiberglass extensions |
Has anyone tried to use the fiberglass wingtip position/strobe extensions
from Vans with the gis-air (x-pak) LED/Strobe system? I am thinking of the
LED system as it is $400.00 versus over $700.00 for the whelen non LED one.
I guess I have problems spending $700.00 for 2 strobes and 4 light bulbs.
If so, did it work? Any problems?
Thanks!
Vince H.
Idaho
RV-8 Finish
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|