Today's Message Index:
----------------------
1. 09:02 PM - Construction question for RV-8(A) Elevator (Garey Wittich)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Construction question for RV-8(A) Elevator |
My Drawing 4PP (circa 2000), which Vans has "somewheres", is confusing to me:
1) This drawing shows the "DIMENSIONS of Elevator Spar E-602PP" (narrow end) with
cutouts of 3/4" X 5/8". What is this cut-out for - does not make sense ??
2) Section B-B: Shows the E-602PP Spar mating to the aft end of the E-604 Rib.
It looks like the aft end of E-604 Ribs "flange" is cut out so as to not interfere
with the E-602PPs "flange" at this point. Is this correct ??
3) Section B-B: Shows a "dashed line" where the above Spar and Rib meet. IF
the aft end of E-604 Rib's flange is cut-out, what does this "dash line" signify
as nothing is there ???
3) Earle in Florida I lost your phone number.
Need a little clarification HELP.
Thank you, Garey Wittich (310) 392-1682 Santa Monica, CA
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|